انتقل إلى المحتوى

اختر لغتك

العربية
Inside a Bitcoin Miner: Hashboards, ASIC Chips, Power Supply and Cooling Explained

Inside a Bitcoin Miner: Hashboards, ASIC Chips, Power Supply and Cooling Explained

Michal BenoMichal Beno
3 November 2026 · Miner Anatomy
Short answer
A Bitcoin miner is a metal box built around a few hashboards packed with ASIC chips that do the hashing. A control board runs them, a power supply (PSU) feeds them, and fans or water plates carry the heat away. Fans and power supplies are the usual wear items, and in a hosted setup the on-site team swaps them under a 7-year warranty for defects.
3,290 W
power draw of an Antminer S21
11,225
BTU of heat per hour from that S21
7 years
OneMiners warranty for defects

1What is inside the box?

From the outside, a Bitcoin miner looks like a loud metal brick with fans on each end. Inside, it is a tightly packed computer built for one task: running the SHA-256 hash function trillions of times per second. That single focus is why it is called an ASIC, short for application-specific integrated circuit. A laptop can do many jobs slowly; an ASIC does one job extremely well.

Every modern Bitcoin miner has the same six main parts. Knowing them helps a buyer read a spec sheet, understand a repair ticket, and see why hosting matters.

Part Its job How it usually fails Who fixes it when hosted
Hashboards Carry the ASIC chips that do the hashing A board stops reporting or runs hot Site technicians
ASIC chips Run SHA-256 guesses non-stop Single chips wear out over years Repair team, board level
Control board The brain: firmware, network, monitoring Rare, often a firmware issue Site technicians
Power supply (PSU) Turns grid power into the right voltage Wear from heat and load Swapped on site
Fans or water plates Carry heat away Fan bearings wear out Swapped on site
Network port Connects the miner to the pool Loose cable or bad port Site technicians
Exploded view of a Bitcoin miner showing hashboards, fans and power supply
Every Bitcoin miner is built from the same core parts: hashboards, control board, power supply and cooling.

2Hashboards and ASIC chips: the engine

A hashboard is a long circuit board covered in rows of small ASIC chips, each bolted under a heat sink or a cold plate. Many air-cooled models carry three hashboards side by side. Each chip makes guesses, and the hashboard adds them up. The total across all boards is the hashrate printed on the label, such as 188 TH/s for the Antminer S21. One TH/s is one trillion guesses per second.

Because the work is split across boards, one failed board does not stop the whole miner. It just lowers the hashrate. That is useful to know when reading the app.

Worked example
Worked example: one of three hashboards goes offline on an S21
Full hashrate 188 TH/s
Hashrate lost (one third) about 62.7 TH/s
Hashprice estimate about 3.5 cents per TH per day
Revenue lost per day (62.7 x $0.0353) about $2.21
If left unfixed for 10 days about $22
A partial failure costs a couple of dollars a day, which is why fast detection matters more than drama. In a hosting centre, staff see the drop and act on it instead of waiting for the owner to notice.
Antminer S21 Bitcoin miner In the catalogue
Antminer S21
Hashrate 188 TH/s
Power 3,290 W
Efficiency 17.5 J/TH
See specs and live price →

3Efficiency: how much power each terahash needs

Chip design decides efficiency, measured in joules per terahash (J/TH). It means how much energy the miner spends to make one trillion guesses. Lower is better, because electricity is the biggest running cost.

The efficiency formula
efficiency (J/TH) = power in watts / hashrate in TH/s
Antminer S21: 3,290 / 188 = 17.5 J/TH. Antminer S23 Hyd: 5,349 / 563 = 9.5 J/TH. Newer chips do the same work for far less power.
How much energy does each miner need per terahash?
Longer bar = more joules per TH (less efficient)
WhatsMiner M50S+
24 J/TH
Antminer S19 XP
21.5 J/TH
Antminer S21
17.5 J/TH
Antminer S21+ Hyd
15 J/TH
Antminer S23 Hyd
9.5 J/TH
Antminer S23 XP Hyd
8.9 J/TH

The newest hydro models need roughly half the energy per terahash of an S21. For a deeper ranking, see the most energy-efficient ASIC miners.

4The control board: the brain

The control board is a small computer, often tucked at one end of the case. It runs the firmware, which is the software that tells the chips how fast to run, reads temperature sensors, and talks to the mining pool. It also hosts the web page technicians use to set the pool address. When a miner is tuned to save power or push more hashrate, the change happens here.

Control boards rarely break on their own. Most 'brain' problems are fixed with a firmware reflash or a settings check, which a hosting team can do remotely or at the rack.

5The power supply: where wear starts

The power supply unit, or PSU, takes power from the grid and turns it into the low, steady voltage the hashboards need. It works hard every second of every day, so it runs warm. Together with fans, the PSU is one of the parts most likely to need a swap over the life of a Bitcoin miner.

Here is a simple fact that surprises many buyers: almost every watt a miner uses ends up as heat. So the power draw also tells you how much heat the site must remove.

Worked example
Worked example: how much heat does a miner make?
Rule 1 watt = about 3.412 BTU of heat per hour
Antminer S21 (3,290 W) about 11,225 BTU per hour
Antminer S23 Hyd (5,349 W) about 18,251 BTU per hour
Whatsminer M79S (14,502 W) about 49,481 BTU per hour
One S21 throws off about as much heat as a large space heater running non-stop. That is why home mining gets loud and hot fast, and why data centres are built around cooling.

6Cooling: fans or water plates

Air-cooled miners push air through the case with fans, usually two at each end. Fans spin fast, make noise, pull in dust, and their bearings wear out with time. Hydro miners replace fans with water plates: metal blocks with channels that carry liquid across the chips. The warm liquid flows to a chiller or dry cooler, gives up its heat, and comes back cool.

How much heat does each miner give off?
Longer bar = more heat in thousands of BTU per hour
Whatsminer M79S (hydro)
49.5k BTU/h
Antminer S23 Hyd
18.3k BTU/h
Sealminer A2 Pro Air
12.9k BTU/h
Antminer S21 (air)
11.2k BTU/h

Hydro units handle much more heat per box, run quieter, and have fewer moving parts inside. The trade-off is that they need a water loop, which only makes sense at facility scale. Read more in air, hydro or immersion.

Antminer S23 Hyd Bitcoin miner In the catalogue
Antminer S23 Hyd
Hashrate 563 TH/s
Power 5,349 W
Efficiency 9.5 J/TH
See specs and live price →
Hydro Bitcoin miner with liquid tubes and a small technician beside it
Hydro miners swap fans for water plates that carry heat to a cooler.

7The network port and why uptime is the real metric

The last part is the humble network port. A Bitcoin miner only earns while it is online and connected to its pool. A loose cable earns nothing. That is why uptime, the share of time a miner is hashing, matters as much as any chip.

Worked example
Worked example: what uptime means in days
Days in a year 365
Offline days at 98% uptime about 7.3 days
Offline days at 95% uptime about 18.3 days
S23 Hyd revenue estimate per day about $19.85
Revenue gap between 98% and 95% about 10.95 days x $19.85 = about $217 a year
A few percent of uptime is worth real money over a year, so a site that keeps miners online is part of the return.
MYTH: A broken hashboard means the whole miner is dead.
FACT: One board offline only lowers hashrate. The rest keep earning while it is fixed.
MYTH: Hydro miners need no maintenance.
FACT: They have fewer moving parts, but the water loop and pumps still need a trained team.
MYTH: More hashrate always means a better miner.
FACT: Efficiency in J/TH decides how much of the revenue is left after power.
MYTH: Repairs mean shipping the miner back.
FACT: In a hosting centre, most fan and PSU swaps happen on site.

8Who looks after all these parts?

The OneMiners view
With OneMiners hosting, technicians at the site watch every Bitcoin miner, swap fans and power supplies, and handle hashboard repairs, while the hosting price includes all management services. Defects are covered by a 7-year warranty, and the network reports 98%+ average uptime with 95%+ guaranteed. Power is fixed for 7 years on the prepaid tier, from 3.6 cents/kWh in Nigeria and 4.5 cents/kWh in Georgia USA (rates as listed on 30 October 2026; check the hosting page for current rates).

Compare sites on the hosting page, or check common questions in the FAQ.

9Frequently asked questions

What is the most important part of a Bitcoin miner?
The hashboards with their ASIC chips. They do the actual hashing, and their design sets both the hashrate and the efficiency.
Which parts fail most often?
Fans and power supplies are the usual wear items, because they run hot and move all day. Hashboards can also develop faults over the years.
Do hydro miners last longer than air miners?
They have no fans inside and run cooler and quieter, which removes a common wear item. They still need a well-run water loop at the site.
What happens if a part breaks while my miner is hosted?
The on-site team diagnoses it and swaps or repairs the part. OneMiners covers defects with a 7-year warranty.
Why does a Bitcoin miner get so hot?
Almost all the electricity it uses turns into heat. An Antminer S21 at 3,290 W gives off about 11,225 BTU every hour.
Own the Bitcoin miner. Let OneMiners power, cool and watch it.
Hosting sites across five continents, power from 3.6 cents/kWh on the 7-year prepaid tier (as listed on 30 October 2026) and a 7-year warranty.
Browse Bitcoin minersSee hosting sites

This article is for education only and is not financial advice. Mining revenue depends on the Bitcoin price, network difficulty, fees, power costs and uptime, all of which change. Figures are estimates based on public network data and rates listed on oneminers.com on 30 October 2026; check the live pages for current rates and prices.

سلة التسوق 0

سلة التسوق فارغة حالياً.

ابدأ التسوق